C2TES1 high-toughness tile adhesive
1. Has high bond strength. Support heavy tiles and stone, reducing
2. Be premixed and produced. Ready to use latex adhesive designed
for interior installations of ceramic tile and natural stone on
both floors and walls.
3. Has strong water retention, no need to dip tiles and wet walls,
thin construction, easy operation, to reduce material consumption
and building load.
4. Has good flexibility to withstand shock and vibration.
5. Has special formula to avoid completely the common phenomenon of
tiles cracking, detaching and peeling by Portland cement.
6. It is non-toxic, non-flammable, non-radiation, non smell and
7. Has special formula to prevent the flow with too much southbound
crash, easier construction.
Scope of application
60cmX60cm tile or above
Tick up tile on old tile
Tick up tile on gypsum board, eterpan, plywood
Treatment of base plane
1. Base plane should be smooth and firm, no dust, grease, release
agents, batik material, etc.
2. Check base plane roughness by 2m ruler, error should be less
3. New plastering cement mortar should be constructed after 14 days
Construction tools: leveling instrument, dentiform drawknife (3 x
3mm、4 x4mm、6×6mm、8×8mm、10 x10mm), tile generator, motor stirrer,
big drum, cross-colloidal.
Stir and mix: mix tile adhesive and water as 25: (6-6.5), stirs
completely and waiting for 5 minutes and stir again.
Lay-up construction: scrape the glue paste evenly on base plane
with dentiform drawknife, the area should be about 1 m each time,
then knead and press on the base plane. The model of the dentiform
drawknife depends on the size of the tiles.
1. The vertical and smoothness of the substrate must be confirmed
2. The product is suitable for construction in the 5-40℃.
3. Don’t use the dried paste by re-adding water.
4. If the base plane is uneven or the back of tile is not smooth,
wiping the paste on the back of brick in order to ensure it full
with paste to avoid hollowing.