C2TES2 high-toughness tile adhesive
1. Has strong cohesion force. Reduce the common phenomenon of tiles
detaching and peeling when pasted by Portland cement.
2. Be premixed and produced, the product is stable, water and used,
to protect the construction environment.
3. Has strong water retention, no need to dip tiles and wet walls,
thin construction, easy operation, to reduce material consumption
and building load.
4. Has good flexibility to resist effectively the destruction of
5. Has special formula to avoid completely the common phenomenon of
tiles cracking, detaching and peeling by Portland cement.
6. It is no-toxic, no-radiation, no smell and environmental.
7. Has special formula to prevent the flow with too much southbound
crash, easier construction.
Scope of application
60cmX60cm tile or above
Tick up tile on old tile
Tick up tile on gypsum board, eterpan, plywood
Treatment of base plane
1. Base plane should be smooth and firm, no dust, grease, release
agents, batik material, etc.
2. Check base plane roughness by 2m guiding rule, error should be
less than 5mm.
3. New plastering cement mortar could be constructed after 14 days
Construction tools: leveling instrument, dentiform drawknife (3 x
3mm、4 x4mm、6×6mm、8×8mm、10 x10mm), tile generator, motor stirrer,
big drum, cross-colloidal.
Stir and mix: mix tile adhesive and water as 25: (6-6.5) stirs
completely and waiting for 5 minutes, stir again.
Lay-up construction: scrape the glue paste evenly on base plane
with dentiform drawknife, the area should be about 1 m each time,
then knead and press on the base plane. The model of the dentiform
drawknife depends on the size of the tiles.
1. The vertical and smoothness of the substrate must be confirmed
2. The product is suitable for construction in the 5-40℃.
3. Don’t use the dried paste by reading water.
4. If the base plane is uneven or the back of tile is not smooth,
wiping the paste on the back of brick in order to ensure it full
with paste to avoid hollowing.
Use level list