SMT x ray inspection system with 530x530mm inspection stage and 10KG load capacity

Price Negotiable

Price: Negotiable

MOQ: 1

Delivery Time: 7 work days

Brand: WELLMAN

Product Description

X-Ray Inspection System with 530x530mm Oversized Stage and 10KG Load Capacity

Key Advantages

Working Principle

Hardware Parameters

X-ray Source

Flat Panel Detector

Table

Equipment Specifications

Safety Features

Radiation Leakage	No leakage
Lead Glass Observation Window	Transparent lead glass window shields radiation to observe inner status
Window and Back Door Safety Interlock	Automatic X-ray power off when opened
Electromagnetic Safety Switch	Locks observation window when X-ray is active
Emergency Stop	Located near operation position for immediate power cutoff
Tube Protection	Prevents software exit without proper X-ray tube shutdown

Software Function

Basic Operations

Function Module	Keyboard and mouse can finish all operations
X-ray Tube Control	Using mouse to click the X button can turn on or off the X-ray. The real-time tube voltage and current value will display beside, users can click up and down button, or drag the slider, or type to adjust.
Status Bar	Indicates the interlock status, pre-heat status, and X-ray status by flashing alternately red and green.
Image Effect Adjustment	The brightness, contrast and gain of the image can be adjusted freely to achieve a satisfactory result.
Product List	Users can save the inspection parameters such as Z-axis position, brightness, contrast and gain, and can directly call the parameters when inspecting the same product, to improve the inspection efficiency.
Navigation Window	After the camera takes a photo of the table, click anywhere in the photo, the table will move to the place you click and display on the screen.
Motion Axis Status	Display real-time coordinates.
Inspection Result	The measurement results (voids rate, distance, area, etc., set by users) display in order.
Speed Control	The movement speed of each axis can be adjusted to slow, normal and fast.

Voids Rate Measurement

Automatic Calculation	Click on two points to determine a rectangle. The software automatically finds and measures the edge of the solder ball in the rectangle, the pad and the internal voids, and can get the data of the voids rate, the area of the solder ball, the circumference, the biggest void's rate, the length and the width, and indicates NG or OK by red and green.
Parameters Adjustment	Users can adjust the grayscale threshold, pixel, contrast, size filtering and other parameters to get accurate results of automatic calculation.
Add Voids Manually	Users can draw a polygon or a free figure and calculate it as a void into the void rate.
Save Parameters	Users can save parameters such as grayscale threshold, pixel, contrast, size filtering and other parameters, and can directly call the parameters when detecting the same product, to improve the detection efficiency.

Other Measurement Functions

Distance	Click the A and B points to set as the baseline, then click the C point to measure the vertical distance from the C point to the baseline.
Distance Rate	It is mostly used to measure the soldering rate of the through-hole. Set one more point "D" than the distance. Divide the vertical distance from the D point to baseline by the vertical distance of the C point, to obtain the percentage ratio of the vertical distance of D to C.
Angle	Click the A and B points to set as the baseline, then click the C point to measure the angle between the BA and BC rays.
Radius	It is mostly used to measure round components such as solder balls. Click three points to determine a circle and measure the circumference, area and radius.
Perimeter	It is mostly used to measure square components, click two points to determine a square, measure the length, width and area.

Automatic Inspection

Manual Setting	Users can set any positions on the table as inspection points, the software will automatically inspect and save the picture.
Array	For the regular inspection points, users only need to set two of the inspection points and the number of rows and columns, the software will automatically inspect each point and save pictures.
Automatic Identification	For inspection points with obvious features, the software automatically identifies the positions, takes measurements, and saves the image.

Application Examples