Rated Input 5mA To 10mA Hall Effect Voltage Sensor Hall Voltage Transducer
Hall Effect Current Sensor Hall Voltage Transducer Rated Input 5mA To 10mA
The TBV5,10/25A series current mode voltage sensor is a device based on the principle of the hall effect, with a galvanic isolation between primary and secondary circuit, It provides accurate electronic measurement of DC AC or pulsed currents.
| Electrical data(Ta=25℃±5℃) |
| Type Parameter |
TBV5/25A | TBV10/25A |
Unit |
Rated input (Ipn) |
5 | 10 | mA |
Measure range(Ip) |
7 | 14 | mA |
| Turns ratio(Np/Ns) | 5000:1000 | 2500:1000 | T |
Primary coil resister |
650 | 200 | Ω |
Secondary coil resister |
110 | 110 | Ω |
Measure resister |
±15V @(±5)±10mAmax 100(min) 350(max) @(±7)±14mAmax 100(min) 190(max) |
Ω | |
Rated output (Isn) |
@Ip=±Ipn ±25±0.5% | mA | |
Supply voltage |
±15±5% | V | |
| Power consumption | 20+IpX(Np/Ns) | mA | |
Zero offset current |
@Ip=0 ±0.2 | mA | |
Offset current drift |
@ -40℃～+85℃ ±0.5 | mA | |
Response time |
40 | µs | |
| Linearity | @Ip=0-±Ipn ≤0.2 | %FS | |
Galvanic isolation |
@ 50HZ,AC,1min 2.5 | KV | |
| Applications |
AC variable speed drives and servo motor drives
Static converters for DC motor drives
Variable speed drives
Power supplies for welding applications
Battery supplied applications
Uninterruptible Power Supplies (UPS)
Switched Mode Power Supplies(SMPS)
| Mechanical dimension(for reference only) |
Remarks:
1. All dimensions are in mm.
2. General tolerance ±1mm
| Directions for use |
The accuracy of sensor will be the best when the current passes through resister R1 and becomes the rated primary current, and therefore the current to be measured by sensor should comply with the primary current 10mA.
For example, VIN=250V:
Accuracy )=±0.8%ofVIN(＠Ta=+25℃) a) R1=25KΩ/10W,IP =10mA
(Accuracy )=±1.6%ofVIN(＠Ta=+25℃) b) R1=50KΩ/ 5W,IP =5mA
Considering resistance of primary coil (compared with R1 and temperature difference kept as low as possible) and electrical isolation within measure range (recommended), this sensor is suitable for measuring voltage.
Standards
- UL94-V0.
- EN60947-1:2004
- IEC60950-1:2001
- EN50178:1998
- SJ 20790-2000
| General date |
| Value | Unit | Symbol | |
| Operating temperature | -40 to +85 | ºC | TA |
| Storage temperature | -40 to +125 | ºC | TS |
| Mass(approx) | 20 | g | M |
| Characteristics chart |
Effects of impulse noise
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.