BXSD-0960-15A BLDC Motor Driver Board with Heatsink, 9-60VDC Input Max Current 17A

Mdel No. BXSD-0960-15A-MG

BLDC motor driver module

(For 120 degree Hall sensor BLDC motor)

Input voltage: 9-60VDC

Working current: 0.1-17A

Hall sensor voltage: 4.5-5.5V

Hall sensor angle: 120 degree

Operating Temp. :-20-60 degree Celsius

Speed control: 0-5V,10K-20K,potentiometer/PWM 200-2000Hz, 0-100 duty cycle

Protections: Locked-rotor protection, over voltage and over current protection.

Application guidelines

1. Confirm that the voltage and power parameters of the motor not exceed the range as specified.

2. Applicable to hall brushless dc motor with Hall at 120°, not all manufacturers' Hall line sequence are same,

you can adjust the Hall wires sequence and motor three‐phase sequence according to the actual situation, to

achieve the best driving effect.

3. BXSD‐0960‐15A‐MG is BLDC motor driver board with heatsink and built‐in connectors, it can used for

12V,24V,36V,48V,60V motors ,Please keep good ventilation for cooling if the motor is more than 300W.

4. The 5V output port(below 100mA) on the driver board is forbidden to connect external power equipment, It

is only applicable to external potentiometer and BLDC motor’s Hall sensors

Wiring diagram

2. Power port

A ‐‐‐‐motor phase U

B ‐‐‐‐ motor phase V

C‐‐‐‐ motor phase W

GND ‐‐‐‐DCVCC‐‐‐‐

DC+

3:Hall sensor port

Ha‐‐‐ Hall a

Hb‐‐‐Hall b

Hc‐‐‐Hall c

GND‐‐‐GND

5V‐‐‐5V

4:Control port

VI—0‐5V /PWM speed control

FB—Forward/Backward

BK—Brake function (0‐5V linear brake, 0‐100% brake power)

SP—Speed pulse output.

5. Use shielded wires if the drivers board has more than 50 cm distance from the motor, otherwise it may lead

to abnormal driving, affecting the normal use.

6. Control port distance: 2.54mm,Power port distance:7.62 mm

Dimensional Drawing