Wireless Solar Motion Sensor Light With 10 SMD LED For Outdoor Lighting

• RANGE OF USAGE 

This solar light is widly used.It was originally designed for plastic toilet facilities, 

but also can be used for a variety of applications.Such as canopies for bikies, 

sheds, plastic toilet, garages, carports, roof, etc. 

• INSTALLATION 

Let the light be charged for at least 8hrs before first time use.According to the 

tube diameter of lamp,cut a hole of 20.5 inch diameter in the roofing and insert 

into the light tube through, screwing the back holding plate and clear lens   

cover back on one in piece. The light will turn on automatically at night when 

movement detected. 

• OPERATION

The light comes with day/night sensor and also PIR motion sensor. It will be 

activated when people present or move in the detecting zone. The light will last on 

as long as movement being detected and it will turn off in 45 seconds after people

leaving detecting zone.

• PARTS

1--- 1 x LED lamp and integrated solar panel

2---1 x Operation Manual

• FEATURES

1. Solar panel: polycrystalline 4V, 260mA

2. Rechargeable battery: lifepo4 battery 3.2V, 1200mAh

3. LED: 10 pieces supper bright LEDs

4. Max.Output Lumen: 65 lumens

5. Operation mode: Light sensor and PIR motion sensor

6. Delay time:45 seconds

Notes

• It is suggested to add a round soft material between light and holding

plate or use glass cement to glue all round of the light.So that water will not leak

into the house and even vapor cannot goes into the lamp.

• For first time use,charge the battery under sunlight for at least 8 hours.
• The light is not suggest to install where have intense air flow or over cold

or over heat place,such as air-condition, as these will make the PIR sensor wrong

function.

• The battery is fixed in the light. When you are going to replace the old

battery,please be mind of the battery polarity.