Servo Motor

3CH Speed Controler Multi RC Digital ESC Servo Tester Motor Tester Servo Motor Features: CCPM Servo Consistency Master / Servo tester The device also can be used as a signal generator for electric speed controller (ESC), then you can test your motor system without using a transmitter and receiver. There are 3 modes to check servos or ESC: Manual mode: turn the knob with different speed, check the reaction time. Neutral mode: make the servo go back to the neutral point.

MG996R Metal Gear Servo 180 Degrees For Boat Car/Truck/ Plane/Robot Description: * Weight:. 55g * Dimension : 40mm x 19mm x 43mm * Operating Speed : 0.17sec / 60 degrees (4.8V no load) 0.13sec / 60 degrees (6.0V no load) * Stall Torque : 13 kg-cm (180.5 oz-in) at 4.8V 15 kg-cm (208.3 oz-in) at 6V * Operation Voltage : 4.8 - 7.2Volts * Gear Type: All Metal Gears * Connector Wire: 11.81" (30cm) Photos: Factory Piture: Our Team: Packing and Shopping: Shopping Ways and Time

3 Pole Ferrite Motor Diy Robot Kit Servo 270 Degree Indirect Drive Specifications: Control System: +Pulse Width Control 1520usec Neutral Required Pulse: 3-5 Volt Peak to Peak Square Wave Operating Voltage: 4.8-6.0 Volts Operating Temperature Range: -20 to +60 Degree C Operating Speed (4.8V): 0.23sec/60 degrees at no load Operating Speed (6.0V): 0.19sec/60 degrees at no load Stall Torque (4.8V): 44 oz/in. (3.2kg.cm) Stall Torque (6.0V): 56.8 oz/in. (4.1kg.cm) Operating Angle:

Description: * Weight:. 55g * Dimension : 40mm x 19mm x 43mm * Operating Speed : 0.17sec / 60 degrees (4.8V no load) 0.13sec / 60 degrees (6.0V no load) * Stall Torque : 13 kg-cm (180.5 oz-in) at 4.8V 15 kg-cm (208.3 oz-in) at 6V * Operation Voltage : 4.8 - 7.2Volts * Gear Type: All Metal Gears * Connector Wire: 11.81" (30cm) Competitive Advantage: 1.Convenient & Friendly Customer Service 2. Low Prices Direct From

MG996R Metal Gear Servo for Diy Robot Kit 180 Degree 11.81" Connector Description: * Weight:. 55g * Dimension : 40mm x 19mm x 43mm * Operating Speed : 0.17sec / 60 degrees (4.8V no load) 0.13sec / 60 degrees (6.0V no load) * Stall Torque : 13 kg-cm (180.5 oz-in) at 4.8V 15 kg-cm (208.3 oz-in) at 6V * Operation Voltage : 4.8 - 7.2Volts * Gear Type: All Metal Gears * Connector Wire: 11.81" (30cm) Competitive Advantage: 1. Convenient & Friendly Customer Service 2. Low Prices

Quick Detail: 1. As long as the input signal end of a50HZ square wave signals. 2. A high pulse duration corresponding to a speed. 3. The high level of 1 ms ~1.5 MS, a high level of 1.5 ms ~2 MS rudder reversal. 4. The steering gear of a regulating potentiometer. Description: - Plastic Gear - Dual Ball Bearing - Original factory product - Less Noise -Contains: Plastic Holder -Orientation Angle:servo 360 degree

Quick Detail: 1.A high pulse duration corresponding to a speed. 2.The high level of 1 ms ~1.5 MS, the steering gear 3.a high level of 1.5 ms ~2 MS rudder reversal 4.Original factory product 5.Less Noise 6.360 degree servo orientation Angle Description: As long as the input signal end of a50HZ square wave signals, and then the cycle of the control signal of high level pulse duration

3.5V - 6V Towerpro SG90 Steering Gear Remote Control Car Parts Hui Sheng9 grams of servo motor SG90/TOWERPRO/9 grams steering gear /25CM (2 pieces/lot) Description: Fraser TOWERPRO SG909G steering gear,19.5CM gray red yellow line 1 weight:9g 2 dimension: 23x12.2x29mm 3 no load operation speed: 0.12 seconds /60 degrees (4.8V ); /60(6.0V ) of0.10 seconds The 4 torque:1.6kg ·cm (4.8V ) 5: use of temperature -30~+60degrees Celsius 6 dead set:5 microseconds 7 working voltage: 3.5V

U-beam Robot Servo Servo MotorBracket Black Silver Color Mounting Bracket Description: 1.Robot servo bracket,U-beam structural member 2.Universal type frame,size fits most about 38g / 55g / 60g servo installation Specification: Material 2mm hard aluminum plate Surface treatment Spray sand oxidation Size 90x29x42mm Weight 20g Color Black, silver Condition Brand new Quality High quality MOQ 10PCS Application DIY Origin CN FAQ 1. What is the terms of payment? L/C,D/A,D/P,T/T

Male to Female JR Plug Servo Extension Cable Servo Motor 15CM 30CM 50CM 100CM Description: 1.100% brand new and high quality 2.Used for RC car,airplane and helicopter servo connection or receiver connection 3.Suitable for receivers 4.All adapter plugs include Specification: Length 15CM/30CM/50CM/100CM Condition Brand new Quality High quality Material Nylon MOQ 50PCS Color As picture Weight 25g Application DIY Origin CN Type Other FAQ 1. What is the terms of payment? L/C,D/A,D