XTOOL Anytoyo SK1 Works With X100 PAD3 and KC501 for Toyota 8A/4A Smart Key Programming
XTOOL AnyToyo SK1 is a data collector as well as a smart key emulator, allows you to do key cloning process in both add key / all keys lost situations for 2013+ Toyota models with smart key. AnyToyo SK1 can also do emergency start when there is no key available on your hand and generate new keys using AnyToyo smart key that comes with the set.
XTOOL Anytoyo SK1 Works With X100PAD3 KC501 for Toyota 8A/4A Smart Key Programming
XTOOL AnyToyo SK1 is a data collector as well as a smart key emulator, allows you to do key cloning process in both add key / all keys lost situations for 2013+ Toyota models with smart key. AnyToyo SK1 can also do emergency start when there is no key available on your hand and generate new keys using AnyToyo smart key that comes with the set.
● Toyota/Lexus key emulator & signal collector
● Works with latest Toyota vehicles with smart keys
● Emulate vehicle keys by immobilizer data read by OBD
● Allow emergency start in all keys lost situation
● Make all keys lost on Toyotas possible by turning SK1 into an existing key
● Collect antenna signals when copying keys
Product Functions:
Supported Vehicle Brands:
Support: 2013-2022 Toyota/Lexus Models With 8A/4A Chip Smart Keys
Parameters:
Port:USB 3.0
Frequency:315/433MHz (RF) 125KHz (LF)
How to Use
1. Collecting data from start/stop button:
· Connect emulator to the tablet and start the process
· When the notice pops up from the tablet, put the antenna close to the start button
· The light will flicker when collecting and goes off when finished collecting
2. Collecting data / emergency start from low-frequency antenna:
· The antenna usually locates at:
1) At the front, beneath the armrest storage area
2) In the middle, under the backseats
3) Door handle (for models with keyless entry)
· Connect emulator to the tablet and start the process
· When the notice pops up from the tablet, put the antenna close to the low-frequency antenna
· The light will flicker when collecting and goes off when finished collecting
· After collecting data, put the emulator close to the antenna and press the start button to do an emergency start.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.