Automatic AC Motor Control Fence Barrier Gate Operator For Parking Lots / Garages
Automatic AC Motor Control Fence Barrier Gate Operator For Parking Lots / Garages
DZ-115 Barrier Gate with Automatic moisture uses the first AC generation motor. It is stable and has long service life performance, running five million times. Its housing is made of galvanized steel with 2mm thickness, and painted, so that the barrier can be used in door and outdoor.
Specification:
2. The fence-type motor adopts die-casting aluminum alloy, which is highly sealed and easy to dissipate heat
3. The motor cooling fan avoids the possibility of overheating
4. The barrier gate automatically reverses when encountering an obstacle
5. Realize automatic closing through the control panel menu setting
6. Barrier gates are used in conjunction with infrared photocells, loop detectors, card readers, ticket vending machines, manual switches (wire control), and traffic lights
7. RS485 communication module
8. Manual release device, operate the barrier gate when the power is off
9. Support external and internal vehicle loop detector (optional)
Motor Speed and Boom Type:
| Boom type | Boom Length(m) | Opening time(S) | Height between boom and ground(M) |
| Straight boom | 6m≥L＞5m | 6S | H=0.83M |
| 5m≥L＞4.5m | 6S | ||
| 4.5m≥L≥3m | 6S | ||
|
Folding boom 90 degree |
5m≥L | 6S | |
|
Folding boom 180 degree |
5m≥L | 6S | |
|
Fence Boom Two-level |
5m≥L≥4m | 6S | H=0.9M |
| 4m≥L≥3m | 6S | ||
|
Fence boom Three-Level |
5m≥L≥4m | 6S | H=1.5M |
| 4m≥L≥3m | 6S |
FAQ:
1. When barrier finish closing, why does the arm open itself slowly?
the spring is too tight, you need release the spring a little, then test it again.
see whether the main crank touch the triangle tightly or not, if tightly, adjust it.
reset the balance position and the electrical limit switch.
2. Why does the controller panel operate with "Di Di Di" abnormal noises?
As for this, it means the resistance on controller board is broken, if you have professional tools to check,
then replace that broken resistance, if not, replace that controller panel.
3. Why does the barrier finish half operation of opening and closing?
If uses our controller panel, you only need to find resistance R37 on controller panel, and repalce it is ok.
4. When barrier closed, why is there a 5 degree angle of inclination?
the model is not good, and the gear doesn't fit each other tightly.
the barrier didn't adjust well, need to reset.
5. When barrier finish open, but it closes itself without any order control, what's the problem?
To check the loop cable first, because the loop cable maybe brokem
To check the motor sensor, if it is not set well, then reset it in the middle between two holes on sensor rod.
6. Why does the arm wave a lot when opening and closing?
The spring is very tight
The Screw touches the rubber absorption tightly, need to reset again.
Contact information:
Sue Zhang
Skype:SueZhang729
Whatsapp:+86 158 7925 9831
Email:sue@wonsunbarrier.com
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.