Vehicle Double Loop Detector For Car Park Management

Quick Detail:

vehicle loop detector

Single channel inductive loop detectorsl 

Application

Loop detectors are used wherever vehicles have to be detected. Like monitoring and safe guarding access ways to counting vehicles. The output signal can be used for controlling door and gate drive mechanisms, operating barriers, controlling traffic light systems in car parks or activating card dispensers in car parks.

The WSTV-410 is a single channel inductive loop detectors. The principle is based on a change in the inductance within the loop which is caused by the metallic components of passing vehicles. The changes are picked up and evaluated by a microprocessor. Ease of use thanks to automatic calibration when the operating voltage is applied.
 

Features:

Reset Switch. Pressing the reset switch enables the detector to be manually reset during commissioning and testing. This results in the detector re-tuning the sensing loop and becoming ready for vehicle detection.

Switch selectable Sensitivity. The detect sensitivity is the minimum change in inductance required to produce a detect output. (%ΔL/L). Eight sensitivity settings are available on the switches to allow flexibility in configuration.

Switch selectable Frequency. The frequency of the loop is determined by the inductance of the loop and the frequency switch setting. If the frequency switch is on, the frequency is reduced. It may be necessary to change the frequency to prevent cross-talk between adjacent loops on different detectors.

Specification:

Supply voltage: 230V AC , 115V AC, 24V DC/AC, 12V DC/AC 

( See the label on the detector) 

Voltage tolerance AC: +10% / -15% 

Voltage tolerance DC: ±15% 

Power Consumption: 4.5VA 

Output relays: 240V/5A 

Operating temperature: -20°C to +65°C 

Storage temperature: -40°C to +85°C 

Frequency range: 20 kHz to 170 kHz 

Reaction time: 100ms 

Signal holding time: Unlimited 

Sensitivity: Adjustable in 3 increments 

Loop inductance: Total loop plus connection wiring: 50μH to 1000μH. 

Ideal is 100μH to 300μH 

Loop connection wiring: Maximum length 20 meters, twisted at least 20 times per meter 

Size of Housing: 78x40x108 mm (L x W x H) 

Contact information:

Sue Zhang

Skype:SueZhang729

Whatsapp:+86 158 7925 9831

Email:sue@wonsunbarrier.com