1*8 Splitter Module FTTH Fiber Optic Spliter Box Uncut Cable ABS White Flame Retardant UL94 V0

FDB0208C is designed for the FTTH application and widely used in Telecommunication networks,CATV networks, Data communications networks, Local Area networks.

Application

1. Widely used in FTTH access network.
2. Telecommunication Networks
3. CATV Networks
4. Data communications Networks
5. Local Area Networks

Features

• Resistance to chemical and U.V attack
• Wall mounting or pole mounting
• ROHS compliance, IP65

• Up to 8 FTTH drops

• Can accommodate 1x4, 1x8 PLC blockless splitter

Specification

Kit content:

There are two ways for fiber splicing.

One (1)is the one of the twelve fibers splices with the 1x8 PLC splitter. Here is about fibe splices with the 1x8 PLC splitter. The other(2) is that fibers directly splice with pigtais.

(1) splice with the 1x8 PLC splitter

A. put one optical fiber out of twelve fibers into the splice protective tube

B. Splice it with 1x8 PLC splitter and put the tubes which had been heat shrunk into groove.

C. After that, coil the extra fiber to the bottom for storage.

D. Fasten the splice tray and screw up the fixing screw of splice tray tightly

(2) Splice with the pigtails.

A. Install the adapter and connect with the pigtails.

B. Then coil the pigtail in the bottom or in the splice tray (the least radium is more than 30mm)

C. After that, put 12 optical fibers into the splice protective tubes separately, splice them one by one directly with pigtails.

D. At last, connect other pigtails from the drop cable entry ports with the other side of adapters.

Product Details

Cable ports, 2 rubber seals with 12mm diamter, 8pcs drop cable round ports 3mm or 2x3mm.

Box lock with metal key and 2 clips, and hinge design, no need to worry the cover will be fall off.

Standard configurate with wall mounting scres, nylon tie, clamps, metal key, sleeeve, number mark, and drop cable protection kits, etc.

Installation method: pole mount, wall mount

Order information