IEC62133 high altitude simulation battery low pressure test equipment

This high altitude simulation battery test equipment is simulating air transport under low-pressure conditions.The design is based on the criterias of UN,EN, IEC and the others. The tester could be reached to the infraba in short time,automatic control test cycle,minitor the whole press of inside barometric pressure.

Procedure: the cells and the batteries shall be stored at a pressure equal to or less than 11.6kPa and hold the value for 6 hours at ambient temperature(20±5°C),so the laboratory temperature should be maintained at (20±5°C).

• High efficiency Temperite Type Oil Separator
• TEMI-300 Programmable LCD Controller
• RS-485 Communication Port/Connector
• Vane Type Sirocco, L134, Fan
• SUS #304 Stainless Steel, PT 100 Ω, Temp-Hum Sensors (2)
• Fin Heat Disperse-Stainless Steel Heater
• PID controlled-Stainless Steel Humidifier

Optional parts:

Communication interface RS232 or RS485, logger, micro printer, remote temperature and humidity control system (including printers, communications software, computer), mobile casters.

Structure:

Overall structure, new test chamber designed very easy to operation and maintenance:

Water and electricity system separation design;

External humidifying design;

Three levels of overheat protection, easy access for refrigeration servicing, etc.

Material:

machines for sheet metal processing;

Tecumseh, Bock Compressor;

High quality electronic components (e.g. DANFOSS, ALCO, RANCO, SPORLAN, SAGINOMIYA, Schneider solenoid valve)

Reference Standards FOR high pressure test chamber :
GB/T 2423.25-2008 GB/T 2423.26-2008 GB/T 150.2A-2009 GB/T10590-2006