High Efficiency Handle Bending Testing Machine/Furniture Bending Tester

1.Product Introduction

The machine is used to test bending strength of handle, under specify load on handle slowly, check the fastness of connection between two parts.

2.Standard Paraments

Servo motor actuator generate a maximum vertical force of 250N
2. A 300N force sensor was used to measure and control the force apply.
3. Load apply gradually without shock , to the handle until the load is supported or record the peak force when the fixing system fails.
4. Torque rod diameter: 10±1mm
5. Fixture: tensile and bend fixture each one
6. Out dimension: (L×W×H) 750mm×452mm×875mm
7. Power: 1 phase, AC 220V, 50～60Hz.

3.More details