3/8" X 25' 4000 PSI Black Jet Washer Hose With Male X Male Swivel Fitting

 
Product Detail 
 

 
 
Product Specification
 

 
If you need other sizes and fittings, please feel free to contact us.
 
Product Picture
 

 
Paishun Advantages
 
* Matched fittings and bend restrictor (protector, sleeve).
* Various colors.
* Free hose sample available.
* Words and your logo can be printed. OEM accepted.
* Strict quality control. Test the products before shipping out with the complete line of test machines.
* Customized hose accepted.
* Factory sale with lower prices.
 
We also produce below products:
* Hydraulic Hoses and Fittings
* PTFE Hoses
* Rubber Air/Water Hoses
* Rubber Gas/LPG Hoses
* Fuel Hoses
* Other kinds of Rubber and Plastic Hoses
 

 Our Products are all CE and ISO certified:

 
Paishun Tips: Operation and Maintenance of Rubber Hose
 
Handling
The hose should be handled carefully and should not be dragged on the sharp and coarse surface, or subject to flexure or crushing, e.g. Vehicle crushing.
Pressure
The hose should operate within the designed working pressure (including impact pressure). It must not operate outside the regulated pressure for frea of unexpected explosion of hose.
Temperature
The operating temperature of hose, either temperature of circulating media or ambient temperature, should not fall outside the range regulated by manufacturer or the suggested range.
Fluid Conveyance
The hose should be used for the designed fluid conveyance or within the range of use. If any question on the scope of application or other fluid or purpose outside the designed range of conveyance, please consult manufacturer and use when allowed.
There should be preventive measures when the hose is used to convey potentially dangerous fluid, e.g. Poisonous, corrosive, explosive or inflammable substances, so as to minimize the hazard of leakage or overflow. It is suggested that the hose not be in a state of filling with conveyance medium.
Bend Radius
The bend radius of hose in service should not be less than manufacturer's regulated or suggested range, because, if not, it may block the fluid conveyance and damage hose. The bend should avoid the place near the joint, otherwise it may aggravate fatigue of hose and thus lead to earlier aging.
Torsional Stress
Generally, the hose should not be designed as being used in the state of torsion. Instead, it should be a mechanical part, the relative movement of which may produce reasonable bend, instead of torsion.
 
 
Please feel free to contact us for any question or request!
 
PASSION FOR HOSE, PASSION FOR YOU!