Specification

Transmitter / Receiver Wireless Heating / Cooling Non-Programmable, with backlight ST23RF

1.Programmability: Non-programmable

2.Display Temperature Range:0°C~40°C (in 0.1°C increments)

3.Adjustable Temperature Range:5°C~35°C (in 0.5°C increments)

4.Temperature measurement accuracy: ±1°C (at 20°C)

5.Defrosting Temperature: +7°C

6.Power source: 2x AAA 1.5V ALKALINE BATTERY

RX:230VAC/50HZ

7.Load Rating: 6(2)A, 230V

8.Low Battery Indicator: Display ““ when battery is less than 2.7V

9.Standby current:5uA, Lighting current ≤ 4.2mA

10.Backlight colour: Orange / Blue

11. Operating Frequency:868.35MHZ

12.Transmission Distance: approx. 50m in open terrain

13. Dimensions: 118 x 80 x 26 mm(without holder)

RX: 86 x 86 x 26 mm

LCD Display

Backlight

The backlight will be ON by press any button and OFF if no any press for 15 secs

Running Mode

Switch by press in different mode:

HEAT (Heating): adjust the temperature by press + or -

COOL (Cooling): adjust the temperature by press + or -

OFF (Frost Protection): it will start heating when the room temperature is under 7°C

Settings

1. HEAT SWING: Hold + and - under the “HEAT”mode for 3 secs to enter the interface of Swing setting (in 0.2~2); Press + or - to set the desired value, then press  to confirm.

2. COOL SWING: Hold + and - under the “COOL”mode for 3 secs to enter the interface of Swing setting (in 0.2~2); Press + or - to set the desired value, then press  to confirm.

3. Calibrate the temperature: Hold + and - under the “OFF”mode for 3 secs to enter the interface of temperature calibration “CAL” (in -3~+3); Press + or - to set the desired value, then press  to confirm.

Reset

Press RESET on the front case for 3 secs to restore the factory default settings.