AC ON/OFF Sensor Widely Used For Parking Lot, With Top Side Dip Switch, Screw Installation, Remote Available
【Product Features】
- Patented coupling dipole antenna design and Adaptive Algorithm, which effectively solves the problem of low installation height of columnar antenna sensors and false triggering caused by side-lobe radiation of the antenna when installed in a metal room.
- Widely used in parking lots and other places, it solves the problem that traditional sensor cannot detect vehicles or the vehicle cannot be detected until it passes directly under the sensor
- Sensor parameters can be set by remote control and DIP switches, easy to configured.
【Parameters】
| Input | ||
| Rated Voltage | 220-240Vac 50/60Hz | |
| Stand-by Power | ≤0.5W | |
| Surge Test | 1KV(L/N,EN61000-4-5) | |
| Output | ||
| Output Signal | ON/OFF | |
| Type of Load | Inductive or Resistive | |
| Load Capacity | 200W@230Vac(Inductive) ; 400W@230Vac(Resistive) | |
| Max. Surge Capacity |
7A relay 20A(50% Ipeak, twidth =200uS, 230Vac full load, cold start); |
|
| Sensor Parameters | ||
| Working Frequency | 5.8 GHz ±75MHz, ISM wave band | |
| Transmitting Power | 1mW Max. | |
| Detection Area(Radius) |
Ceiling mounting height 3m: r≥4m@0.3m/s, r≥2.5m@1m/s; Wall mounting height 3m: r≥5m@0.3m/s, r≥4m@1m/s Test condition: Set 100% sensitivity, open 60㎡ indoor area. |
|
| Mounting Height | 3m (6m Max) | |
| Hold time |
5s/30s/90s/5min/20min/30min (Dial code) 5s/30s/1min/3min/5min/10min/20min/30min (MH10 setup) |
|
| Detection Area | 100%/75%/50%/25% | |
| Daylight Sensor | Normal Daylight |
2Lux/10Lux/30Lux//50Lux/Disable 5Lux/15Lux/30Lux/50Lux/100Lux/150Lux/Disable (MH10setup) |
| Operating Temperature | -25℃…+60℃ | |
| Storage Temperature | -40~80℃ Humidity: ≤85% non-condensing | |
| Certificate Standards | ||
| Certified | CE, RED | |
| Environmental Requirements | Comply with RoHS 2.0 Reach | |
| IP Rating | IP20 | |
| Other | ||
| Remote Model | MH10; MH16; MH03 | |
| Wiring | Press-in Type Terminals, wire diameter: 0.5-0.75mm2 | |
| Installation | Built-in | |
| Package | Bubble bag+Clapboard + Carton(K=A) | |
| Net Weight | 40.3±3g | |
| Lifetime | 5 years warranty@Ta | |
【Function】
| ON/OFF function | Light control Disable or external brightness value is lower than the set value. When the microwave sensors detects the movement of an object, the sensor triggers and enters the light-on state. It maintains the light-on state after a delay and then enters the light-off state. |
| Two-step dimming function | N/A |
| Three-step dimming function | N/A |
| Daylight harvesting | N/A |
| Daylight priority | N/A |
【Product Information】
- Dimension(units: mm)
- Function & Wiring
Antenna installation tips
Suggestion: The bottom Angle of the light plate from the microwave antenna should be higher than 2mm, otherwise the induction distance will become closer
【DIP Switch Setting】
| Function | Daylight Sensor | Hold Time | Detection Area | ||||||||
| Dial code | 1 | 2 |
3 |
Daylight Sensor Threshold | 4 | 5 | 6 | Hold time | 7 | 8 | Detection area |
| Ⅰ | ON | ON | ON | 2Lux | ON | ON | ON | 5S | ON | ON | 100% |
| Ⅱ | - | ON | ON | 10Lux | ON | ON | - | 30S | ON | - | 75% |
| Ⅲ | - | ON | - | 30Lux | ON | - | ON | 90S | - | ON | 50% |
| Ⅳ | - | - | ON | 50Lux | ON | - | - | 5min | - | - | 25% |
| Ⅴ | - | - | - | Disable | - | ON | ON | 20min | N/A | N/A | N/A |
| Ⅵ | N/A | N/A | N/A | N/A | - | - | - | 30min | N/A | N/A | N/A |
- Radiation Pattern
【MH10 Remote Control】
The sensor should be installed by a professional electrician. Please turn off the power before installing, wiring, changing the setting of the DIP switch.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.

