Supports LED hot swap 1-10V PUSH 25W LED Dimmer Driver Module
with Short Circuit Protection
 
Description:

• Flicker-free for whole dimming range
• Stand-by power below 0.5W
• Primary & secondary dimming with push button
• 1-10V dimming
• Dim via a potentiometer
• Supports LED hot swap
• Protection: short circuit/ over temperature/ over voltage
• Derating current for over high ambient temperature.
• Dimming level memory at mains restores
• Multi-output currents set via dip switches
• 5-year warranty
•  

Applications:
For LED down light, LED panel light, led strip, led tube etc…
 
 
Dimming Operation:
 

1) Push button switch for dimming 

• ON/OFF: Short push (0.12s~0.4s) on the switch.
• Dimming: Long push (>8s and <15s) on the switch. Dimming range 2%-100%, it takes 8s from the darkest to the brightest. Self recovery when blackout.
• Synchronization: If there is Led driver is not synchronized when the same PUSH switch is connected to the driver, long press the PUSH switch (>15S), the LED driver will stay at 50% brightness. (LED current will be the 50% of the maximum current), and achiever automatic synchronization.

2) 1-10V dimming

When the LED driver is on, it can achieve dimming by rotating the 1-10V dimmer, the dimming range is 2-100%. When the 1-10V dimmer output is 1V, LED will be adjusted to the darkest and LED current will be the 2% of the maximum current. When the 1-10V dimmer output is 10V, LED will be adjusted to the brightest and LED current will be the 100% of the maximum current.