Remote Controlled LED Photography Lights Ultra Bright Aluminum Housing​

Product Specifications 

Accesssories Including

1. Barndoor
2. Diffuion Panel & White diffusion panel
3. AC power adapter 12V 60w and 
4. Remote controller
5. Power cord
6. Carrying bag

Operation instructions

1. Install the battery onto the light.Connect the light to camera by the hot shoe.Turn on the power switch and the light works.

2. There is a power indicator light on the back of the light.Turn off the light and press the power test button to check the battery level.

3. The battery level shows as below:

4. Please adjust the brightness of LED508A.Please adjust both the brightness and color temperature of LED 508A accordingly.

5. The four columns in the front of the light are for attaching a diffuser.You can attach a diffuser and adjust the pillar height to get different soft lighting effect .

6. When the battery runs out,press the installation and uninatallation button to take off the battery.It takes 4-5hrs to recharge it.

7. A 40W adapter and 60W adapter is respectively provided for directly supplying power to the LED508A.

Cautions: 

1. It is no need to replace the LED bulbs in normal use.Please do not disassemble the light or solder the LED bulbs by the non-professionals.

2. Please do take off the batteries when in storage.

3. Please do not block the louvers,or it may seriously influence LEDs' effect and lifetime.

4. The charger adapter is used for battery charging only.Please do not use on the light directly.

5. Please do discharge and recharge the battery at least once for every month if it is not in use.

6. It is not allowed to drop or impact the light to avoid fire.

7. It is not allowed to short circuit the battery,or it may seriously damage the battery or cause a

    fire.

8. It is not allowed to throw the battery into fire.

Warranty:  

The LED light is guaranteed for 12 months.

The battery is  guaranteed to be charged and discharged for 500 times.