Hot-pluggable SFP+ 12G Video SDI Optical Cable Module With LC Fiber Connector
SFP Module: Video SFP 12G SDI BIDI 1270/1330nm SM 10KM LC DDM / Pass Pathological Signal
Overview
It is an excellent product, which is a series of high-performance optical modules, suitable for high-speed serial links over single-mode optical fiber at signaling rates up to 12.5 Gbps.
Because of its hot-pluggable capability, it can be installed in or removed from any MSA-compliant pluggable small form factor port, whether the
host equipment is operating or not. Furthermore, it supports a DDM function and detailed product information stored for retrieval by host equipment.
For further information, please refer to the SFP+ Multi-Source Agreement (MSA).
The transceiver operates up to a 12.5 Gbps data rate from a single +3.3 V power supply.
Features
-
Operating data rate up to 12.5 Gbps
-
Compliant with SFP+ MSA, SFF 8431 Rev 4.1
-
Digital Diagnostic SFF-8472 compliant
-
Uncooled CWDM DFB Laser transmitter & High sensitivity PIN PD Receiver
-
Single +3.3V power supply
-
Up to 10km Transmission on 9/125 μm Single Mode Fiber
-
Single LC connector
-
Very low jitter
-
Very low EMI and excellent ESD protection
-
Low power dissipation
-
RoHS compliant
-
Pictures
Application
1. SMPTE compatible with serial digital interface
2. UHDTV/4K/8K/HDTV/SDTV video
3. IP media gateway
4. Digital video processing and editing
Reminder
1. It is recommended to use the short optical fiber link for the first time to ensure that all the functions of the equipment are normal, and then do long-distance transmission
2. The signal of the fiber optic converter can be output to the power amplifier, but the audio source of the power amplifier can not be output the audio source signal to the fiber optic converter, otherwise the equipment will be burned
Troubleshooting of the indicator
1: Power indicator is abnormal (POWER)
Answer: Check whether the power adapter meets the equipment requirements or the power adapter fails
Whether the socket is not tight or loose
2: Fiber indicator is abnormal (FIBER)
Answer: Check whether the optical fiber interface is loose and not plugged in
Check whether the optical fiber is too attenuated
3: Video indicator is abnormal (VIDEO)
Answer: Check the signal source
Replace the video cable
4: Data indicator is abnormal (DATA)
Answer: Check the COM port, whether the baud rate is consistent
Check whether the serial port cable is connected backward
Attention
Lightning protection, static electricity, and grounding:
It is recommended that when installing the device, consideration should be given to the impact of grounding by lightning and prevention measures. Strong static electricity will damage the optical device and data chip in the equipment. It is recommended that when plugging/unplugging the data port of the optical converter, please disconnect the power supply of the optical converter first.
Fiber and optical components:
Be careful when plugging the optical fiber, as the optical components of the optical converter are very fragile, and you should avoid causing damage to the optical components. It should be noted that the light source produced by the optical components of the optical converter will be harmful to the eyes, so do not have direct eye contact with the optical components ofthe optical converter. If you need to detect the optical power of the optical converter, please use the optical power meter.
Equipment and installation procedures:
1. Optical fiber installation: Please carefully insert the optical fiber into the optical fiber interface of the optical terminal after confirming that the optical fiber link meets the installation requirements.
2. Equipment installation: The equipment can be distinguished between transmitter and receiver, and it is stated clearly on the label and printed on the chassis of the equipment.
Packaging & Shipping
Payment
Welcome to inquire!
Contact Information
Company Information
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.