- Single face, single spring, unbalanced, rubber bellows structure.
- The seal face is driven through the spring, and spring seat, good floating.

- Rotary Ring: B, Q2, U1, U2
- Stationary Ring: Q2, U1, U2, V1
- Spring and Other Parts: F, G

- Pressure: ≤ 1.6MPa
- Temperature: -20~140℃
- Speeds: ≤10m/sec
- Viscosity: ≤ 1.0Pa.s(1000cp)(Soft VS Hard); ≤ 3.5Pa.s(3500cp)(Hard VS Hard)

Used in centrifugal pumps, mixers, and other rotating equipment.

Liquid waste of grains, sewage water, oil, etc.

Mechanical Seal MG1 Advantage

1. Fine workmanship
The product is exquisitely manufactured, and production is strictly in accordance with international standards. Any non-conforming product is prohibited from leaving the factory.

2.Energy-saving and environmental protection

When the double-end mechanical seal is running, the sealing cooling water is recovered and reused through the water inlet and outlet holes. When the seal is a single end face, the set can be used as a water-free seal, thereby fully achieving the effect of energy-saving and environmental protection.

3.No leakage
There will be no start-up leakage during use, and the seals are tested before going out of the factory.

4. Structural characteristics
Easy to install, no need to measure the working length of the seal during installation; easy to remove, take out seals for cleaning and inspection without disassembling the pump equipment

Mechanical Seal MG1 Size Information