ASTM SE 1025 Plate Penetrameters, X ray flaw detector accessories, American Inspection Standards

 
 
 
ASTM SE 1025 Plate Penetrameters, X ray flaw detector
 
accessories, American Inspection Standards
 
 

 
 
ASTM SE 1025 Plate Penetrameters are normally used to conform with the American Inspection
 
Standards. They are rectangular plates, 2% inthickness of the specimen and of material
 
radiographically similar to the  specimen. Each plate has three holes drilled equal in diameter to
 
1X, 2X,and 4X the plate penetrameter thickness. The minimum thickness of Plate type
 
penetrameter is 0.010’’. For Penetrameters greater than 0.180’’, these are supplied in disc form,
 
the outside diameter is 4X, with 2 holes 1X & 2X the thickness of the Penetrameter.
 
 
The chart below gives Plate Penetrameter Identification and thickness and a guide as to which
 
penetrameter to use for each material thickness.
 

TAG: Wire Penetrameters