FAQ

Q: What is the role of this cable in a proximity transducer system?
A: This cable carries the output from the 8 mm probe tip to the sensor electronics (Proximitor) in a 3300 XL proximity transducer

system. It enables non-contact eddy‑current measurement of shaft position / vibration.

Q: What are the key electrical/mechanical specs for the cable?
A: The cable is 75 Ω coaxial, with typical capacitance ~ 69.9 pF/m. The ClickLoc connectors are gold‑plated

 and corrosion‑resistant. The design ensures signal integrity between probe and sensor.

Q: What are system limitations or what must be verified when using this cable?
A: The overall performance (linearity, accuracy, noise immunity) depends on the full transducer system

 — not just the cable. The linear measurement range, sensitivity, and calibration depend on

 the matched probe, target material, and sensor electronics. For critical applications, the

 whole assembly should be configured per the manufacturer’s datasheet

and calibrated appropriately.