Smooth Operation Domestic Floor Cleaning Machine With Human Engineered Design

Product Uses

Press both sides of screw box inwards and pull it out; take out screw by impact. Align the mounting hole of control handle with the mounting hole of chassis, install the screw and tighten the nut; Put screw box into on chassis.

Keep pad holder or brush flat on the floor, take hold of chassis and lift machine with both hands, align brush holder pad with pad holder or brush, push chassis hard, make pad holder or brush level and place it properly.

Lay the machine on its back with the handle lying on the floor; Turn over chassis backward and shown pad holder or brush, remove pad holder or brush on the brush holder pad.

Rotate the handle to the highest point, insert the pin in the special-purpose hole of motion, hold tight handle and makes the two wheels drop to the ground, than can push or pull the machine to move.

Spec:

1. 22.2V, 2200mAhLihtium battery
2. BLDC motor, 150W with rotating speed 80000 rpm
3. 0.8L Dust capacity
4. Speed control
5. Up to 14Kpa vacuum
6. Working time up to 30 Min
7. Charging time:4-5H
8. Noise≤68db