Good Film Performance , Optional RAL Colours , Highly Glossy And Matt

1.Features

1.The product does not contain toxic, non solvent and non volatile toxic substances, so no poisoning, no fire, no "three wastes" pollution and other public hazards, fully in line with the requirements of the national environmental protection law.

2.The utilization of raw materials is high, the powder produced by some famous brand powder suppliers can be recycled, and the highest utilization rate can reach more than 99%.

3.After the pretreatment, the coating can get enough film thickness without bottom coating. It is easy to realize automatic operation, high production efficiency and lower cost.

4.The coating is dense, adhesion, impact strength and toughness are good, the edge angle coverage is high, and it has excellent corrosion resistance and electrical insulation property.

5. Powder coating storage, transportation safety and convenience.

2.Advantages:

1.High Efficiency: Because It Is Disposable Membrane, It Can Increase Productivity 30-40% 2.Save Energy: Reduce Energy Consumption By About 30%.

3.Less Pollution: No Organic Solvent Volatilization (Not Containing Toluene, Xylene And Other Harmful Gases In Paint).

4. The Coating Utilization Rate Is High: Up To 95%, And The Powder Can Be Used Repeatedly After Recovery.

5. Film Performance Is Good: Disposable Film Thickness Can Reach 50-80 M, Its Adhesion, Corrosion Resistance And Other Comprehensive Indicators Are Better Than The Paint Process.

6. Finished Product Rate Is High: Before Curing, It Can Carry Out Two Times Re Injection. There Are Many Kinds Of Powder Coating Process, And There Are Two Kinds Of Electrostatic Powder Spraying And Plastic Dipping.

Powder Coating Is A New Type Of Solid Powder Coating Without Solvent 100%. It Has The Characteristics Of No Solvent, No Pollution, Energy And Resources Saving, Labor Intensity Reduction And Mechanical Strength Of Coating Film.

3.Tips

1.keep away from fire sources and avoid direct sunlight, should be placed in a well ventilated place below 35 C.

2. Avoid storage in places where water, organic solvents, oil and other materials are contaminated.

3. Powder coating should not be exposed to the air at any time, should be stamped at any time or tighten the bag to avoid debris mixing.

4. Avoid long term contact with skin. Apply powder to soap and rinse water. Do not use solvent. The safety of the construction site

5. Painting equipment should be well grounded to eliminate static electricity.

6. Avoid the phenomenon of unprovoked discharge of the coating machine

7. In the powder spraying room, the concentration of the floating dust should be controlled below the safe concentration as far as possible so as to avoid the danger of dust explosion.

4.Description