Touch Screen Control Textile Vertical Burner

Application

The equipment is suitable for all kinds of fabrics and their products such as safety nets, protective clothing, safety belts, etc., and finally applies to the test method for the burning performance of the vertical side of the textile as specified in GB5455-2014.

Technical parameters

1. Touch screen display / control
2. The equipment is divided into two parts: the control part and the combustion box. The size of the combustion box is 330*330*765mm.
3. The front part of the combustion box is a tempered glass observation door
4. The top of the box is evenly distributed with 16 exhaust holes, the inner diameter is 12.5mm; there are 6 exhaust holes on both sides of the combustion box, and the inner diameter is 12.5mm.
5. Top of the box is attached to the top
6. The top of the box is provided with a bracket, and the bottom of the model clip is located 17mm above the highest point of the igniter nozzle.
7. The inner diameter of the igniter nozzle is 11mm, and the head and the vertical line are at an angle of 25°. Ignition time: accurate to 0.05s
8. Gas source: industrial grade propane, butane or propane / butane mixed gas, using methane gas with a purity of not less than 97% when the sample is pretreated according to 7.3
9. Sample size: 300*89mm, five horizontal and vertical
10. Ambient temperature: -10 ° C ~ 30 ° C
11. Power supply voltage and power: 220V±10% 50HZ Power less than 100W
12. Bunsen burner flame time 0-99M99S, can be arbitrarily set, accuracy ± 0.01s
13. Yu Yan, afterglow time: the longest 0-99M99S
14. Bunsen burner blue flame height: 15mm-175mm can be adjusted freely, with flame height scale
15. Bunsen burner auto-ignition, automatic timing, ignition time can be set arbitrarily (can be preset)
16. Touch screen related parameters:
a. Size: 7 inches Effective display size Length 15.5cm Width 8.6cm;
b. Resolution: 800*480
c. Communication interface RS232, 3.3V CMOS or TTL, serial port mode
d. Storage capacity: 1G
e. Use pure hardware FPGA driver display, “zero” startup time, run on power
f. Using M3+FPGA architecture, M3 is responsible for instruction parsing, FPGA focuses on TFT display, speed and reliability are leading the same scheme
g. The main controller adopts a low-energy processor and automatically enters the energy-saving mode.

Product advantages
Textile vertical burner textile horizontal vertical burner textile horizontal vertical burner textile horizontal vertical burner
1. Touch screen display / control
2. The equipment is divided into two parts: the control part and the combustion box. The size of the combustion box is 330*330*765mm.
3. The front part of the combustion box is a tempered glass observation door
4. The top of the box is evenly distributed with 16 exhaust holes, the inner diameter is 12.5mm; there are 6 exhaust holes on both sides of the combustion box, and the inner diameter is 12.5mm.
5. Top of the box is attached to the top
6. The top of the box is provided with a bracket, and the bottom of the model clip is located 17mm above the highest point of the igniter nozzle.
7. The inner diameter of the igniter nozzle is 11mm, and the head and the vertical line are at an angle of 25°. Ignition time: accurate to 0.05s