Mask Flame Retardant Tester​

Product Introduction

This mask flame retardant tester is developed according to GB2626 and is used to test the fire retardant performance of masks. The applicable standards are: GB2626 GB19082 GB19083 GBT32610 YY0469 YYT0969, etc.

Technical parameters

1. The mask head mold is made of metal and simulates human facial features according to the ratio of 1: 1.

2.Burner height adjustable

3.Automatic positioning timing

4. Display afterflame time

5. Equipped with flame sensor

6. Head mold moving speed (60 ± 5) mm / s

7.Diameter of flame temperature detection needle 1.5mm

8. Flame temperature adjustment range 750-950 ℃

9. Accuracy of afterburning time 0.1S

10.Power source 220V 50HZ

11. Gas: propane or liquefied petroleum gas

Operation interface introduction

Test interface

Positioning: Click on the head mold to stop above the torch to adjust the direct distance between the torch and the head mold

Run: The head mold starts to move toward the torch and stops after reaching the other position

Exhaust: open and close the exhaust fan on the box

Gas: Open and close the gas passage

Ignition: start high pressure ignition

Lamp: Turn on and off the lighting inside the box

Save: Save the test data after the test is completed

Timer: Recording the after burning time