Stainless Steel Grating Walkway 40mm Bearing Bar Pitch Twisted / Round Bar

Galvanized stainless serrated bar steel grating stair treads

Bar grating types are specified by bearing bar spacing followed by cross rod spacing. In imperial measurements, bearing bar spacing is described in sixteenths of an inch. Therefore, Type 19 has bearing bar centers at 19/16 of an inch (or 1 3/16”). Type 15 has bearing bar centers at 15/16”. Type 11 is at 11/16” etc. The second number after the dash in the Type designation refers to the cross rod spacing. Cross rods are available in either 4” (standard) or 2” (special) spacings.

All bar grating Types may also be described in metric units. Again, the first number represents the bearing bar spacing on centers and the second number represents the cross rod spacing, both units measured in millimeters. Therefore, Type 30-102 Metric equals bearing bars at 30mm centers and cross rods at 102mm centers. This is the metric equivalent of Type 19-4.

Note: Although the special 2” (50mm) cross rod spacing does allow for less open space on the grating surface, it does not affect the load rating of the grating. The most economical and readily available choice for bar grating selection is Type 19-4 (Type 30-102 Metric).

U= Safe Uniform Load, in lbs per sq ft or kPa
C= Safe Concentrated Load in lbs per foot of grating width or kN per metre of grating width
D= Deflection in inches or mm

Specifications

SS 316 Industrial Grating:
bearing bar:25x3mm, 25x4mm, 30x3mm
bearing bar pitch:40mm,
ISO 9001:2008
twisted bar pitch:50mm

SS 316 Industrial Grating:
bearing bar:25x3mm, 25x4mm, 30x3mm
bearing bar pitch:40mm,

twisted bar pitch:50mm
ISO 9001:2008

stainless steel grating platform introduction-- steel platform grating

Application: