AKC200A083 Compressor Car AC For Suzuki Swift For SX4 For Fiat Sedici 1.6 WXSK037

AKC200A083 Compressor Car AC For Suzuki Swift For SX4 For Fiat Sedici 1.6 WXSK037

The function of the car air conditioning compressor is to compress and circulate refrigerant gas within the air conditioning system. This process allows for the transfer of heat from inside the car to the outside, resulting in a cooler and more comfortable interior temperature. The compressor pressurizes the refrigerant, which increases its temperature and converts it into a high-pressure gas. This high-pressure gas then flows to the condenser, where it releases heat and condenses into a liquid. The liquid refrigerant then goes through an expansion valve or orifice tube, where it expands and cools down, ready to absorb heat inside the car again. The compressor plays a crucial role in the overall functioning of the car's air conditioning system by facilitating the circulation and transformation of refrigerant.

Parameter :

Installation and Testing

To test a car air conditioning compressor, you can follow these steps:

1. Start by visually inspecting the compressor for any signs of damage or leakage.
2. Measure the voltage at the compressor's electrical connector using a multimeter to ensure it is receiving power.
3. Check the clutch engagement by turning on the air conditioning and observing if the compressor clutch engages and spins freely.
4. Use a manifold gauge set to check the high and low side pressures. Compare the readings to the manufacturer's specifications to determine if the compressor is functioning properly.
5. If all other tests indicate a fault with the compressor, it may need to be removed and taken to a qualified professional for further testing and repair.

When it comes to installing a car air conditioning compressor, it is recommended to follow these steps:

1. Start by removing the refrigerant from the system using a refrigerant recovery machine.
2. Disconnect the electrical connector and any mounting brackets or bolts securing the compressor to the engine.
3. Remove the drive belt and any other components obstructing access to the compressor.
4. Replace the old compressor with the new one, ensuring the fittings are properly aligned and any gaskets or seals are in place.
5. Reinstall the mounting brackets, bolts, and electrical connector.
6. Reinstall any components that were removed to access the compressor.
7. Evacuate and recharge the system with the appropriate amount of refrigerant following the manufacturer's guidelines.
8. Test the system to ensure the compressor is functioning properly and there are no leaks.

Please note that it is recommended to consult the vehicle's service manual or seek professional assistance for specific instructions on testing and installing a car air conditioning compressor.

Product pictures

Warehouse/Delivery