Main characteristics,

Advantages of the new soft light bar

1.Widely used, easy to install and maintain, long service life

2.Very flexible, easy to bend into different shapes, various white light options
3.COB Design, with more chips on PCB, more even light.
4.Up to 528 chips on 1 meter PCB, only 2.0mm space between chips.
5.Cuttable at every 22.73mm/ 45.45mm length. Form a circuit without affecting other circuites.
6.Efficiency up to 100Lm/W.
7.Ra 90 also available.
8. Can be customized according to customer requirements

Installation precautions

1. In the installation process, sharp objects should be avoided from touching the surface of the lamp strip, so as not to damage the colloid and cause undesirable effects;

2. Avoid contact of colloid in luminous area with high-temperature objects to avoid scalding colloid and affecting linear effect;

3. Select DC24V stabilized voltage power supply to drive, and select a power supply with appropriate power according to the number of lamp strips to be installed; The total power of each power-driven lamp belt shall be less than 80% of the rated power of the power supply;

4. It is strictly prohibited to bend or twist the lamp strip in a short distance to avoid damaging the rubber strip or damaging the internal electrical structure of the chip, as shown in the figure 4:

5. Pay attention to waterproof and moistureproof.

6. it is suggested that any bending diameter of the lamp band should be > 1CM, as shown in the figure 5: