Gutter brush works by filling your gutters and creating a complete 360 degree barrier to leaves and other debris while allowing water to filter and flow freely through the Gutterbrush and downspouts. Also, GutterBrush gutter guards work perfectly with your existing gutters and roofing materials so there are no costly modifications to be made when installing the GutterBrush.

Customer Satisfaction is Guaranteed!

Professional grade, quality construction, and superior craftsmanship assures that your GutterBrush gutter guards professionally installed by Pro Property Maintenance will keep your gutters from clogging with leaves and other debris while also lasting for many years to come.

5 PCS TO ONE CARTON . ONE PC WITH LOGO CARD

 
Size:10*100CM,12*100CM,10*200CM,12*200CM,10*300CM,12*300CM,10*400CM,12*400CM

 
How to install the Weixuan Gutter Brush Leaf Guard

Before installation ensure that any leaves/debris are removed and the gutters/drains are clean.
It is very important that the correct diameter brush is chosen for your gutters or drains. The brush must fit snugly in position without any gaps either side. If the brush is allowed to ‘rattle’, it will be much less effective and is likely to be blown out. If you measure the inside width of the gutter and it is, say 90mm, the correct diameter of brush would be the standard 100mm diameter.

 
The filaments at the top of the brush should extend slightly above the level of the tiles or slate.
 
N.B. Although perfectly suitable for standard 100mm square or round profile gutters, the 100mm diameter Gutter brush will suit most gutter profiles and styles including Deepflow, Ogee and Classic profiles.
 
The brushes should run continuously along the whole length of your guttering. When one brush finishes, bend the excess wiring at the end of each brush backwards to form a hook and simply attach the two brush ends together to continue the run. The brushes can run directly across the down pipe or drain outlets. If there is excess brush at the end of the run, just cut the excess of with a pair of wire snips but make sure you leave approximately 50mm overrun, then just untwist the wire to remove excess filaments, re-twist the spine and bend into a hook shape and secure into the gutter. Job done!