Stainless Steel Continuous Gap Wire Wrap Screen Pipe OD 219

Slit vibrator is composed of a set of cylindrical shaker with straight equipment. There is a bias block or a bias wheel at both ends of the cylindrical shaker. When the motor drives the bias wheel to rotate, centrifugal force occurs and is transmitted to the equipment on the main shaft in the cylinder, so that the main shaft moves in a circle around the center line fixed on it.

Because the two supporting rings are located in opposite directions of the roll and parallel to each other, a gap is formed between them parallel to the horizontal plane. When the material enters from the feed end, it falls into the lower discharge port through the gap, and the other part of the material is discharged from the discharge port and discharged out of the machine through the discharge tank.

Material

Stainless steel

Grade

304

O.D

219mm

Size

8"

Length

300mm-6000mm, 2.9m, 5.8m

Slot size

1.0 mm

End connection

Thread Couplings (male/female)

Wire size

93 #

Support rod

140 #

Wire shape

V shape

• Not easy to jam: The special V shaped wire makes the hole of screen outside face smaller than inside, so the hole is not easy to jam.
• Slot even: The CNC machine tools strictly control the gap between the wire, so that the gap is even.
• Strong corrosion resistance: Stainless steel 304 has high corrosion resistance.

• Material: Stainless steel 304, 304L, 316, 316L, 321. Low Carbon Steel Galvanized
• Diameter: 30 - 1000mm (63mm, 89mm, 117mm, 168mm, 219mm, 273mm, 325mm, 377mm etc.)
• Inch: 3", 4", 6", 8", 10", 12", 14", 16" etc.
• Length: 2.9m and 5.8m standard lengths, custom lengths 300mm - 6000mm available
• Slot size: 0.2mm, 0.5mm, 0.7mm, 1.0mm, 1.5mm (0.1 - 45mm range)
• End connection: Welded rings, thread couplings (male/female)
• V wire: 63 #, 93 #, 118#, etc.
• Support rod: Diameter 300mm, 350mm, 380mm, 400mm, 480mm, 500mm etc.

We can manufacture the screen pipe according to customers' specific requirements!

Johnson wire wrap screen is manufactured with V-shaped profile wire which is spirally wound around a cage of longitudinal support rods. Each intersecting point of these wires is fusion welded. The pitch of winding gives different spacing between two adjacent turns of wire. This spacing gives passage for water to enter. The entire process is completed on fully computerized machines.