Furnace heating fuel change from natural gas to Electric heating

Furnace heating fuel change from natural gas to electricity

Step 1, Remove the zinc kettle platform 拆除炉窑的锌锅平台

拆除前 Before removal 拆除后 After removal

Step 2, Disassemble the furnace, expand it by 200mm on each side, and add a gate at the flue outlet (if natural gas heating is no longer used after the renovation, it’s no need to expand the furnace.) 将炉窑拆开,分别往四周各扩大200mm,并在烟道出口位置增加闸门.(如果改造后不再使用天然气加热,则不需要将炉窑扩大.)

Step 3, Lift the heating plate vertically into the furnace and guide the heating wire out of the furnace. 将加热板垂直吊入炉窑,将加热丝引出炉窑.

Step 4, Connect the heating wire to the electrical cabinet with cable. 将加热丝与电气柜用电缆连接.

Product advantages:

1) The heating wire is made of Cr20Ni80 material, good high-temperature toughness, non-brittle, fast heating and high precision;

2) The heating plate frame is made of 310S stainless steel material, with high structural strength and excellent high-temperature resistance;

3) The power control adopts a dedicated power regulator, featuring high accuracy and stable performance.

4) Easy to install, requiring only remote guidance to complete installation and debugging.

产品优势:

1) 加热丝采用Cr20Ni80材质,高温韧性好,不脆,升温快,精度高.

2) 加热板框架采用310S不锈钢,结构强度高,耐高温性能好.

3) 功率控制采用专用调功器,精度高,性能稳定.

4) 设备安装简易,仅需远程指导,业主即可完成安装调试.