3000 1 / Min Industrial Servo Motor / CNC Router Servo Motor 0.91A SGMPH-01AAA41

Industrial Servo Motor SGMPH-01AAA41 Yaskawa 0.00000364 kg.m² 3000 1/min 0.91 A
 
 
 
QUICK DETAILS

1. Rotor inertia : 100W
2. Rated Speed:3000 1/min
3. Rated Current : 0.91 A

 
DESCRIPTION

• AC Servo Motor
• SGMPH Sigma II
• CNC Router PLC

 
 
SEPCIFICATIONS  

 
 
 
Be sure to set this parameter when installing an external regenerative resistor. When set to the factory setting of “0,” the SERVOPACK’s built-in resistor has been used. Set the regenerative resistor capacity tolerance value.
 
 
When the set value is improper, alarm A.320 is not detected normally. Also, do not set other than 0 without connecting the regenerative resistor because alarm A.300 or A.330 may be detected.
 
 
The set value differs depending on the cooling method of external regenerative resistor:
 
 
• For natural air cooling method: Set the value maximum 20% of the actually installed regenerative resistor capacity (W).
 
 
• For forced air cooling method: Set the value maximum 50 % of the actually installed regenerative resistor capacity (W). Example: Set 20 W (100 W)
 
 
IMPORTANT
 
 
1. When resistors for power are used at the rated load ratio, the resistor temperature increases to between 200 °C and 300 °C (392 °F and 572 °F). The resistors must be used at or below the rated values. Check with the manufacturer for the resistor’s load characteristics. Use resistors at no more than 20% of the rated load ratio with natural convection cooling, and no more than 50% of the rated load ratio with forced air cooling.
 
 
2. For safety’s sake, use the resistors with thermoswitches.
 
 
 
DIMENSIONS 




 
TORQUE CURVE



 
SIMILAR PRODUCTS

 
 
 
OTHER SUPERIOR PRODUCTS
Yasakawa Motor, Driver SG-