Brushless Ac Servo Motor , High Rpm Servo Motor SGMAS 04ACA2B 200V 2.6A

Industrial Servo Motor SGMAS-04ACA2B Yaskawa Motors-AC Servo 200V 2.6A
 
 
 
QUICK DETAILS

1. Power : 400KW
2. Voltage:200V
3. Voltage : 2.6A

 
DESCRIPTION

• AC Servo Motor
• SGMAS Sigma II
• Yaskawa Motor 

 
SEPCIFICATIONS

 
 
 
Set user constant Cn-02 so that the reference pulse form matches the host controller output form
 
 Input a slow speed pulses from the host controller and execute low-speed operation.
 
 Check the following items in monitor mode
 
 
 
(1) Has a reference pulse been input?
(2) Is the motor speed as set?
(3) Does the reference speed match the actual motor speed?
(4) Does the motor stop when no reference is input?
 
To change motor speed or the direction of rotation, reset the user constants shown below.
 
 
If an alarm occurs or the motor fails to rotate during the above operation, connector 1CN wiring is incorrect or the user constant settings do not match the host controller specifications.
 
This is all that is required to complete step 1 (conducting a test run for motor without load). Whenever possible, perform tuning associated with the host controller and other necessary adjustments in step 1 (before installing the motor on the machine).
 
 
When using a servomotor with brake
 
The brake prevents the motor shaft from rotating due to a backdriving torque. Such a torque may be created by an external force or the force of gravity acting on the load and may result in undesired motion or the load, should motor power be lost.
 
Servopack uses the brake interlock output (BK) signal to control holding brake operation for a servomotor with brake.
 
 
NOTE
 
To prevent faulty operation caused by gravity (or external force), first check that the motor and holding brake operate normally with the motor disconnected from the machine. Then, connect the motor to the machine and conduct a test run.
 
        
 
 
 
 
 


 


 


SIMILAR PRODUCTS

 
 
 

 
 
OTHER SUPERIOR PRODUCTS