500 Micron Porous Sintered Wire Mesh Screen Ultra Fine Plain Weave

500 micron ultra fine stainless steel porous sintered knitted Wire Mesh screen

Description of stainless steel sintered mesh round for filter plate 

5-layer sintered stainless steel mesh

It is our standard sintered mesh structure. A single layer of fine wire mesh was placed between two thicker square woven meshes, which were then added to two layers of strong Dutch woven wire mesh and sintered together to form a sturdy board. A single layer of fine wire mesh acts as a filter layer that can be customized to meet specific filtration levels, ranging from 5 microns to 300 microns. It can then be cut and made into a variety of discs, tubes, cartridges and plates.

Filter sintered mesh material

AISI304, AISI304L; AISI316; AISI316L >>Check chemical composition

Special alloy steel Hastelloy, Monel, Inconel and Titanium alloy can be customized according to customer requirements

Filter size

Standard sizes: 500x1000mm, 600x1200mm and 1000x1000mm, 1200x1200mm, and other sizes.

Filtering technology expression

Initial bubble point pressure

The bubble is the minimum pressure required to force the gas to impregnate the porous material Pa through the liquid.

Average aperture

The average pore size as determined by the foam principle, in μm.

Relative permeability coefficient

Unit differential pressure, fluid volume flows through the filter element per unit area, the unit is L / min.cm2.Pa.

Viscous permeability coefficient

Dynamic Viscosity Unit of Fluid When the fluid resistance is formed only by viscous losses, the unit pressure gradient, volume flow rate through the filter element per unit area in m2.

Note: This list for a reference, not for the complete list.