FTTH Insert Loss SC APC UPC Fast Connector Fiber Optic Components

Field installation connector is a new kind of connector that could be used in FTTH project scene.

They don’t need to polishing, no epoxy. They could be installed in the field and make connection

less than two minutes. Of course, It don’t need fused the fiber.

Just some little tools enough, so it could save time and cost.

We could offer embedded type fast connector. This connector has a bare fiber insert in the ferrule.

The front end face was polished in advance. The fiber mating point is in a precision C groove.

Most of Common Fiber Fast Connector is traditional technology with V-groove, main materials are glass ,plastic,and metal.

Disadvantages On V-Groove:

1,The poor butt joint's deformation is caused by V-groove forming process because the plastic rigidity is not good.

2, The thermal expansion and cold shrinkage change greatly if V-groove with Plastic materials.

Thus, the product can not work stably at -40~+85 ℃ environment.

3,After the long service of poor butt joint , both plastic and metal materials are prone to aging deformation or rust,

4,Groove easily deforms under force ,making docking point miss match ,inceasing.

The original, and Hicorpwell high quality fast connector with C-Groove (Ceramic Groove )

Advantages On C-Groove (Ceramic Groove ):

Ceramic material insure insert loss (IL) ranges less than 0.1db,when dealing it in high temperature ,low temperature,

or high low temperature cycle.

By the illustration,we could see clearly the insertion loss ranges following the temp.