Flexible Size From China Multi functional Accept ODM and OEM Network Wiring Tools Factory YH8005

Traction line

When the construction staff encounters the need to wear the pipe through the pipe, the wire is often pulled by the construction staff. Because the toughness and strength of ordinary iron wire are not designed for wiring traction, the operation is extremely inconvenient and the construction efficiency is low, which may also affect the construction quality. In foreign countries, "drawing lines" have been widely used in wiring projects as a deployment tool for data cables or power cables.

American IDEAL Zoom 31-092 30.5m Pull Wire

The special traction wire material has excellent flexibility and high strength, and the surface has a low coefficient of friction coating, which is convenient for passing through the PVC pipe or steel pipe and greatly improves the efficiency and quality of the cable laying operation.
According to the relevant provisions of the integrated wiring design and acceptance specification:

• Line box device should be set every 30 meters (98 feet) of straight line pipe

• When the length of the pipe section with an elbow exceeds 20m, the cable box device should be installed
• When there are 2 bends, no more than 15m should be set over the box device
Therefore, a 100-foot (30.5-m) traction cable is most suitable.
For the vertical trunk section, it should be laid down from the high level to the bottom layer. With the help of the weight of the cable, a maximum of 10 to 15 cables can be pulled at a time. After the cable is pulled out, the 30 cm line should be cut to avoid stress affecting the cable structure. The horizontal cables should be laid in a harness, away from electricity, heat, water supply, and gas pipelines to prevent them from being damaged by grinding, scraping, filing, and dragging.
When wiring in the pipeline, in order to ensure the electrical performance of the wiring and easy to operate, pay attention to the utilization of the diameter. For multi-layer shielded cables, flat cables, large logarithmic backbone cables or optical cables, the straight pipe utilization rate is 50% to 60%, and the bent pipework should be 40% to 50%; laying 4 pairs of twisted horizontal cables or 4 cores When the optical cable is used, the interface utilization of the pipeline should be 25% to 30%. The following formula can be used to calculate the number of wires in the tube:

Pipe utilization = cable diameter / pipe diameter