Super Thin HEPA Filter FFU (Fan Filter Unit) with HEPA Filter

Product Description

Ultra thin FFU is generator set with super thin motor inside which is used in the turbulent layer and laminar flow clean room, where have limited installation space. Its speed can also reach to 0.45m/s ±20% same as other FFU.
It is 100mm thinner than the ordinary FFU.The material of cabinet is stainless steel, Galvanized steel with aluminum painting, Cold rolled steel with epoxy powder and so on. It is lighter, corrosion-resistance, rust-resistance and beautiful.

Features

1. Overheating protection
Inside equipped with overheating protection, the surface is smooth and bright, lower air resistance and good sound insulation. Special air entrance design can low down the noise effectively .
2. The average air velocity increase to 25% Long-life span, energy-saving, low noise, less maintenance, small vibration and adjustable speed. The average air velocity increase to 25%.
3. Life-long span It works as an average air speed of 0.45m/s. The outlet speed is stable and can shorten the period the replace filters. In the meantime, it can extend the service life of fans.
4. Space-saving
Light and convenient, easy and beautiful design. Let the using space reduced largely and the efficiency is higher. Not only improve the scope and space, but also energy saving.

Technical Data Sheet

Voltage: 120/240 V
Material: Stainless Steel
Size: 2'x2', 2'x3', 2'x4'
Specification: 575*1175*180mm
Filter: ULPA, HEPA
Filter Replacement Access: Room-Side, Top Side
Housing Material : Galvanized / Stainless Steel
Noise Level: <60 dB
Fan Type: Aluminum Turbofan

Parameters Table