Automatic Armature Winding Machine For Slotted Commutator No Hook Skew Rotor
Automatic Armature Winder For Slotted Commutator No Hook Skew Rotor WIND-ST-TD2B
Application:
Armature winder for no hook slotted type commutator armature,Vacuum cleaners hammers power tool
Advantages:
1. No need to work with special designated slotting undercutting machine
2. Slotted type armature save copper wire and reduce cost comparing to hook type armature,
but winding slotted type armature can be a challenge,
WIND-ST-TD2B is the best winder for slotted type commutator in Chin among winder manufacturers
4. 98% yield rate above assured based on the commutator quality is good
Fully automatic winding machine filed Japan machine manufacturers are the pioneer, the rising demand
for high quality products and low labor cost, operator only need to ensure enough raw materials, and
replace them in time without workpiece or copper wire, so that continuous production can be ensured.
The number of shaft is usually high, so as to achieve high efficiency production. A machine with enough
automation can meet the requirements of an employee handle two or three winding machines at the same
time.
Suggestion:
1. What is Wire size and Wire slot size(Length,width and depth) data
Wire size 17AWG (1.15 mm), Slot: blade width 1.143, length=7.14 mm,
depth= 5.95 mm
In normal condition,the wire slot should have enough space for the wire to stay inside
and Wind Automation think if the depth is bigger, the wire can acquire more space to stay inside slot,
while depth is more, length is more too
2. Could you please check if the commutator was pressed consistanctly each time at same location
according armature stack?
The push pin witness marks on the commutator are consistent, so commutator slotting is even uniform
Armature commutator and stack position is very important for indexing consistantly
|
Wire Gauge |
Usually 0.20~1.2mm, Max machine handled 1.35mm (about AWG16)
|
|
Commutator type |
Slotted type riser type not hook type commutator
|
|
Automatic or semi |
Automatic,operator only need to load and unload armature, other actions such as
hooking, winding, indexing and cutting are carried out by winding machine
automatically
|
Please click below picture to view video
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.