Semi Auto SMT Mounting Machine 1400*800*1680mm Size PCB Screen Printing Machine

Semi-auto stencil printer 600mm ET-S600

Application:

In smt production line, it is conbied by stencil printer, pick and place machine, reflow oven, these three most important machine.

Our machine ET-S600 is the type of semi-autonatic stencil printer, suitable for semi-automatic smt line.

Features:

ET-S600 suitabel for max pcb size:250*550 mm, the pcb thickness is 0-50 mm.

ET-S600 printing speed is 0-800 mm/min

The repeatability preciison is reach 0.01 mm.

The positioning mode is outside or reference hole.

Manual feeding board, machine printing, low price, high precision, high cost performance

printed circuit board graphics alignment:

The optical positioning point (MARK point) of the substrate and the stencil on the workbench is centered by the printer camera, and then the X, Y, and z of the substrate and the stencil are finely adjusted to make the substrate pad pattern and the stencil opening. The graphics are completely coincident.

Attention:

1. The use of solder paste should strictly follow the guidelines for the use of solder paste. Only one-third of the bottles can be placed on the steel mesh at a time. Stirring was resumed after 4 hours of printing. Solder paste bottles should be scraped clean to prevent waste. Pay attention to the recovery of the solder paste on the steel mesh and scraper.

2. The printer should be careful when using and installing the stencil. The mixing knives should not be placed on the steel mesh to prevent damage to the stencil and scraper when the squeegee is pressed down. Special attention should be paid to the placement of the thimble. Other debris other than the thimble should not be placed under the steel mesh.