Expanding Polyurethane Foam Insulation Construction Sealant PU Foam 750ML

Surface Preparation

lSurface should be cleaned of dust and mortar clods

lSurface should be sprayed with water using water sprayer

lProtect window profiles from the foam’s outgrow

Product Preparation

lThe can temperature should be between +10 ºC to +30ºC

lOptimal temperature of can is +20 ºC

l If can temperature is too low, the product should be put into warm water of +30 ºC for 15 minutes or left overnight in room temperature.

Product Application Instruction

lShake the can vigorously(20-30 seconds valve down) in order to mix the components

lScrew the can onto the adaptor

lThe working position is valve down

lVertical gaps should be filled from down to up

lDo not fill the whole gap-foam grows in volume

l If you fill window or door gaps, the gaps maximum gap size should be 3 cm. Foam should not be used in gaps larger than 5 cm.

lThe speed of application and the thickness of the bead should be controlled by the adequate pressure on the gun or adaptor trigger.

l If you stop the application for time longer than 5 mins, remember to shake the can before continuation of works.

Finishing Works

lThe excess of foam should be cut after the foam has cured. The foam should not be pushed back into the gap when it’s still uncured as it will cause structural defects and worsen insulation effect.

lAfter the foam has fully cured it should be protected from UV by mortar or paint.

l If you want to keep using the same can after longer time the gun and the adaptor and valve should be cleaned with the cleaner for polyurethane foams.

l Mechanical connectors recommended for doors mounting

Packing Details:

Detailing Images