Transmission Line Tool Integral Manual hydraulic Tool in Plastic Case Package

Performance Parameter

Check whether the pressed terminal matches the wire specification.Instructions

1. Select the mold you want to press, such as the gauge of the pressed terminal 240², then select the upper and lower mold of 240².

2. Put the mould into the piston and head seat respectively.

3. Repeatedly start the operation handle and watch the mold. When the upper and lower molds meet a profit, the pressure is finished.

    

   Note

   If the user does not pay attention to continue the start, the pump will have the sound of "click click click click", which will be opened for the safety protection device, the piston stops moving, the operating handle should be rotated clockwise so that the top part is pressed down against the top village, then the piston will return to its original position.