5.8GHz C-band frequency

120-277V AC, 60Hz.(US version)

220-240V AC, 50Hz.(EU version)

0~10V DC output signal.

(PWM version available on request)

Step1: Long press “Start” button for 2s till green LED permanent on, then input all desired settings by
pressing the buttons in each function zone, the green LED will flicker once to indicate the operation
success.

*After 2s, start to input the parameters, interval time each function zone button will be within 10s.
Otherwise, need re-operate step 1 for memory scene.

Step 2: 

Press “Memory” button to memorize all settings parameters.
Green LED will flicker ONCE to indicate the operation success.

Step 3: Press “Apply” button to copy the same settings to other sensors, point the remote control to the
receiving sensor for min. 2s. Red LED will flicker to indicate the operation success, the receiving sensor
will buzz also to indicate success receival.
e.g., setting detection range 50%, daylight threshold 200lux, hold-time 30s, dim off 1h, dim level 10%,
the steps should be:

1. press “start” button for 2s, choose “50%”, “200lux”, “30s”, “1h”, “10%” function zone button.
2. press “memory” button.
3. press “apply” to other sensors, then all of them will share the same settings.