Reuse 50 times hollow plastic concrete formwork,concrete wall extrusion machine
 

With increasing environmental awareness and the influence of policy, green construction material is more and more popular.

ACEMIEN pp hollow sheet making machine has been tested by market and will be a great innovation of construction material.

 ACEMIEN plastic hollow formwork is a successful innovation of construction material and has been accepted by many Asian countries. plywood formwork price can reach more than 60 reusable times and have more excellent performance than traditional plywood: green, energy efficient and economical.

 Installation instructions:

• 1,Use the hollow building formwork intersecting surface laid with 15 mm thick.

• 2,Wood square of the distance :

  • 1, On the surface of the intersection (spacing: wood square distance according to the thickness of the slab concrete, in general, the thickness of less than 0.15 m floor (spacing is 200 ~ 250 mm.

  • 2,The shear wall (spacing: (spacing according to adjust the spacing, height and thickness of the wall to wall height of 2800 mm, 300 mm thick wall, for example, using the formwork (15 mm thickness spacing is 100 ~ 150 mm, if the shear wall, pillar width more than 1 meter, must add the fixed frame.

  • 3, Die shear wall and column puzzle when leaving no gaps, internal Angle (the bottom of the wall) parts must have wood square, beam, wall, formwork connection.Shear wall made 4 after the mold must be assembled into the whole hoisting, then lay flat, reduce labor intensity, forming effect is good.

 
Features of plastic construction formwork:

Advantage:
 

General Operation And Notes Of Instrument For formwork board system :

• Method of use as well as wooden formwork, pvc bridge formwork reinforcement direction with batten direction placed in cross shaped.
• No need to smear the mold release agent before using board formwork.
• When cast-in-place the flat plate, spacing between the keels should be 20 ~ 25 cm, and the spacing between the wall plate and keels hould be 10 ~ 20 cm. ACEMIEN formwork board system don't need releasing agent.
• The seam-line between pvc bridge formwork should be taped.
• The length of nail should not be too long, generally about 30 ~ 35 mm.
• The strength to drive nailsshould be moderate.
• When removing the board formwork, please start from the small part of one end, the support and the plates should be removed at the same time aiming at preventing the template widespread drops, don't let the corner drop on the ground vertically.
• The formwork board system accesses to be mixed used with wood veneer, bamboo veneer and other material plate