Seamless Butt Welding Alloy Fittings Target Tee 6"X SCH-60S Titanium Gr2 Pipe Fittings

Seamless Butt Welding Alloy Fittings Target Tee 6"X SCH-60S Titanium Gr.2 Pipe Fittings

Introduction

Target/Cushion Tee are manufactured from forged material. Their main characteristic is a blind branch.
Through the analysis of the way in which the corrosion has an effect on the surface of the Target/Cushion Tee blind branch, the level of corrosion of the piping material can be measured.
In case Target/Cushion Tee are manufactured from forged material, it is possible to manufacture dimensions and forms according to customers' requests.

Overview and features:Hastelloy C22

Titanium alloy has high strength and low density, good mechanical properties, good toughness and corrosion resistance. In addition, titanium alloys have poor processing properties and are difficult to cut. In hot working, it is very easy to absorb impurities such as hydrogen, oxygen, nitrogen and carbon. There is also poor wear resistance and complex production process. The industrial production of titanium began in 1948. The development of the aviation industry requires the titanium industry to grow at an average annual rate of about 8%.

Cutting characteristics

When the hardness of titanium alloy is greater than HB350, cutting is particularly difficult, and when it is less than HB300, it is prone to tool sticking and difficult to cut. However, the hardness of titanium alloys is only one aspect that is difficult to machine, and the key lies in the comprehensive impact of the chemical, physical, and mechanical properties of titanium alloys on their machinability. Titanium alloy has the following cutting characteristics:

(1) Low deformation coefficient: This is a significant feature of titanium alloy cutting, with a deformation coefficient less than or close to 1. The distance of chip sliding friction on the rake face is greatly increased, accelerating tool wear.

(2) High cutting temperature: Due to the small thermal conductivity of titanium alloy (only equivalent to 1/5-1/7 of 45 # steel), the contact length between the chip and the front cutting surface is extremely short, and the heat generated during cutting is not easily transmitted, concentrated in a small range near the cutting area and cutting edge, resulting in high cutting temperature. Under the same cutting conditions, the cutting temperature can be more than twice that of cutting 45 steel.

Q1: Are you trading company or manufacturer ?

A: We are factory.

Q2: How long is the delivery ?

A: 15-30 working days

Q3: Do you provide samples ? is it free or extra ?

A: Yes, we could offer the sample for free charge but do not pay the cost of freight.

If you want to get more information of the products, send me e-mail or by skype, whatsapp etc.

.

If any questions,you can call me mobile phone at any times:0086-15710108231