65 Ton Capacity Solid Wheels Transport Platform For A Copper Melting Process Hold High Temperatures

Xinxiang Hundred Percent Electrical And Mechanical Co., Ltd, With 17 years of production experience, it can produce more than 100 non-standard customized electric transport platforms, such as rail transfer platforms, battery flat platforms, large-scale intelligent transportation AGV, and rail intelligent RGV. The company is located in Yulin, Yanjin County, Xinxiang City. With its own factory area, the annual production capacity can reach about 2000 custom electric flat cars.

 abrasive tool service department battery service maintenance free battery marketing department device maintenance go straight

The product has the following advantages

1: Simple operation; wireless remote control, like a toy remote control car, basically every employee can operate it skillfully.

2: Flexible operation; this 65 ton capacity solid wheels transport platform for a copper melting process hold high temperatures has no track constraints, can move flexibly in the workshop, and the body can make 360-degree turns without dead ends.

3: Operational safety; every 65 ton capacity solid wheels transport platform for a copper melting process hold high temperatures made by BEFANBY is equipped with a device that stops automatically when encountering people and objects. The safety problem can be greatly guaranteed during the operation of the workshop.

4: The load capacity is strong; the 65 ton capacity solid wheels transport platform for a copper melting process hold high temperatures made by our company can achieve a load of 1 ton to 100 tons. If it exceeds 100 tons, you can choose to use the track type electric flat car. Our company can do 1 ton. To a load of 1,000 tons.

 abrasive tool service department battery service maintenance free battery marketing department device maintenance go straight

What are the daily maintenance tasks for using electric flat cars? A brief introduction is as follows:

1. During the use of the electric flat car, the technical status of each part should be checked regularly, and the dust, water, oil and iron filings that may enter the body should be cleaned up in time and protective measures should be taken.

2. The air duct of the motor must be unobstructed, and no heat source can be placed around the motor. If problems are found, take preventive measures in time.

3. Under normal circumstances, replace the grease every six months. When replacing the grease, first wash the bearing with kerosene or gasoline, and then fill up two-thirds of the bearing chamber with grease. Too much or too little is not good for lubrication.

4. The motor should be overhauled regularly, usually once every three months, and overhauled once a year. If the motor winding is burnt due to an accident, it should be disassembled and analyzed in time. Usually the secondary winding is burnt out due to start switching failure or capacitor short circuit; the main winding burnout is caused by long-term overload or starting stall. Replace the motor windings and eliminate the cause of the accident before reuse.