4 Layers Blow Moulding Machine For High Barrier Pesticide Bottle

Introduction:

MP90FS IML is specifically designed for making bottles from 600ml up to maximum 10L. It is hydraulic driven with accrate eletrical control system. MP90FS IML has single stations to increase the production efficiency. Also, it has variety of choice of die heads. With more than 10 years of success in the market, MP70FS IML is updated to be one of the most reliable and popular model in the world.

Adjusting of blow pin

Do adjust blow pin before normal operation begins, or pen will be damaged. So after change of placing rack oil cylinder or mould installation position, blow pin must be adjusted again. It is required that blowing mouth should insert mould bottle mouth, central lines of blowing mouth and mould bottle mouth should match and conform, and force of blow pin should be proper. Adjusting methods are as follow:

1) Start machine manually. Make mould rack move down to end point and close. Make blow pin fall slowly and stop when blowing mouth approaches mould bottle mouth. For safe, before this operation, adjust the adjusting cover of blow pin oil cylinder to position where blow pin will not touch mould, even if it falls completely. Watch whether blowing mouth centralizes with bottle mouth or not.