1.1hp Hydroponic Centrifugal Water Pump , Swimming Pool Sand Filter Pump
Hydroponic Water Pump 1.1hp Complete With Tank Swimming Pool Sand Filter Pump
| Model | Voltage | HZ | Power (KW) | Power (HP) | Hmax (m) | Qmax(m³/h) | Port Size (inch/mm) |
| FQS-370 | 220V-240V | 50 | 0.37 | 0.5 | 8 | 11 | 1.5/50 |
| FQS-550 | 220V-240V | 50 | 0.55 | 0.75 | 12 | 16 | 1.5/50 |
| FQS-750 | 220V-240V | 50 | 0.75 | 1 | 13 | 17 | 1.5/50 |
| FQS-1100 | 220V-240V | 50 | 1.1 | 1.5 | 15 | 21 | 1.5/50 |
| FQS-1500 | 380V | 50 | 1.5 | 2 | 16 | 25 | 1.5/50 |
Features:
- Approved by ETL and CETL
- Pump, flange,impeller use high quality plastic.
- With electric current overloaded protector,Low noise.
- Good sealing performance.
- Good appearance,easy to use and maintain
- Silent operation
- Can resist chemical in swimming pool
- Pool motor with 48 frame
- Overload protection
- Huge pro-filter for less cleaning maintenance
- Arrange drain device of water pump
- Suitable for all types and sizes pools, in-ground spas
FAULT ANALYSIS
1. Disconnect switch or circuit breaker off position
2. Fuses fusing or thermal protector open
3. Locked motor shaft
4. Motor winding burned out
5. Defective staring switch inside single phase motor
6. Disconnected or defective wiring
7. Low voltage
LOW PUMP CAPACITY
1. Inlet or discharge valve partly closed
2. Inlet or discharge valve partly plugged
3. Inlet or outlet too small
4. Hairs or foreign lugged strainer
5. Dirty filter
6. Impeller clogged
PUMP DOES NOT REACH FULL SPEED
NEVER run pump dry! Running pump dry may damage seals, causing leakage and flooding! Fill
pump with water before starting motor.
Before removing lid:
STOP PUMP before proceeding.
CLOSE GATE VALVES in suction and discharge pipes.
RELEASE ALL PRESSURE from pump and piping system.
NEVER tighten or loosen screw while pump is operation.
PERFORMANCE: This Pool Pump takes care of cleaning, filtration and chlorine/salt distribution. features a removable strainer basket with a built-in thermal overload protection as the water circulates and passes through the filter leaves your pool clean.
Factory Introduction
FREESEA group has been engaged in pool filtration industry for more than 15 years. Mainly produce pool filtration equipment: Sand filter, circulation pump, vaccum air blower, etc. It is located in Ningbo city Zhoushan island, we provide OEM service for many famous pool brand in foreign & domestic market. Pumps annual output more than 20 thousands. We accept different standard(USA, EU, CN etc).Has many branches in China main city and Spain, sales network extend to all over the world.
Get in Touch
Have questions about our products or want to discuss a custom order? Our team is ready to help you.