Steel decoiler

The Hydraulic De-coiler is used to hold and drive the steel coil that is being fed into the roll forming machine. The de-coiler allows for a quick change of steel coli with minimal manual labor. The de-coiler is powered with a feedback system that ensures the roll former is not required to turn the coil. The de-coiler will turn as required to reduce the potential for over coiling. Maximum coil mass: 10,000 kg

      Nominal coil ID: 500mm supplied with addition spaces to use 600mm above

      Maximum coil OD: 1300mm

      Maximum coil width: 1300mm

      Machine consists of the following major items:

• Machine frame

• Overhung shaft with roller bearing

• Drive motor and chain

• Hydraulic power pack (shared power pack on top /bottom coil)

• Hydraulic cylinder of expansion/retraction

• Solenoid valves

• Electrical control system

• Limit system to allow positioning of de-coiler for different feed positions. Manual positioning with position indicator.
• Coiler Car-Powered loading bed to aid in loading to the de-coiler.