Cross Wire Feeding In Coil Building Brick Force Metal Wire Mesh Welding Machine

Environmental conditions for Cross Wire Feeding In Coil Building Brick Force Metal Wire Mesh Welding Machine

In order to make machine playing a better performance, we must pay more attention to the following requirements for site selection and equipment layout.

1. The ambient air temperature is about 5 ~ 40 ℃;

2. Air relative humidity: 20 ° C Max. 90%, 40 ℃ Max. 50%;

3. The elevation should be lower than 2000 meters;

4. The device must be away from the large vibration equipment;

5. The dust, acid, corrosive gases or substances in the air around the workshop do not exceed normal levels;

6. No outdoor use, it must be used inside the plant, and have specialized personnel to guard the door;

7. Away from the place of the strong magnetic field;

8. Power: AC(380V 50HZ), we suggest adopting a separate transformers of 80-315KVA with a distance less than 50m and the cable should adopt the copper wire of 90 mm²;

9. Water: Provide clean and neutral circulating cooling water, inlet temperature in Summer is not greater than 40 ° C (the referring volume of cooling water is no less than 2 cubic meters), 0.2 ≤ pressure ≤ 0.3MPa

10. Gas: screw rod air compressor with a providing pressure ≥ 0.8MPa and a gas production volume ≥ 2.3m³/min; the air tank with a pressure ≥0.8MPa and a volume≥1m³/min. We suggest you to use the matching air dryer.

The overhangs of meshes cut by this device are very short, which can save material cost for you.

1) The length of the steel mesh can be arbitrarily settled by editing the production parameters to meet different needs.

2) The cutting range of mesh width is 1500mm. It can be adjusted according to user needs.

3)The cutting speed of mesh is controlled by the PLC

4) It adopts pneumatic cutting with big pressure, which can easily cut 16pcs wires with diameter 3-6mm.